I've been trying different gentoo-sources, now I'm at 3.12.13, but it didn't change anything. It initializes the scanner (sled is moving) and then some seconds nothing happens.ģ) Instead of the xsane window an error message pops up:įailed to open device 'epkowa:interpreter:003:006': Error during device I/O.Ĥ) If I now run xsane again its window pops up most of the time, but sometimes I have to power off the scanner and start at (1) again, until it works. usb 3-4: ep 0x2 - rounding interval to 128 microframes, ep desc says 255 microframesĢ) I run xsane. usb 3-4: ep 0x81 - rounding interval to 128 microframes, ep desc says 255 microframes usb 3-4: New USB device strings: Mfr=1, Product=2, SerialNumber=0 usb 3-4: New USB device found, idVendor=04b8, idProduct=0131 usb 3-4: new high-speed USB device number 6 using xhci_hcd After buying a new PC and installing 64bit Gentoo I can't use the scanner "the easy way":ġ) I power on the scanner and it's detected: I've been using the named scanner for years without any problem on my old PC (32bit Gentoo). Posted: Sat 9:44 am Post subject: Strange Epson Perfection V300 Photo (USB) problem Gentoo Forums Forum Index Kernel & Hardware Strange Epson Perfection V300 Photo (USB) problem Gentoo Forums :: View topic - Strange Epson Perfection V300 Photo (USB) problem
0 Comments
Leave a Reply. |